- ページ 3

フロアマシン Edic ENDEAVORのPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。Edic ENDEAVOR 15 ページ。 Multi-purpose extractor
Edic ENDEAVOR にも：オーナーズ／オペレーターズ・マニュアル (17 ページ)

INITIAL INSPECTION:

Every machine that EDIC builds has been meticulously tested and inspected by multiple personnel before being

packed and shipped. This machine has left the factory in good condition and free of defects or damage. Any

damage has happened after leaving the factory and is the responsibility of the carrier. The carrier must be

notified immediately if there is any damage.

CHEMICAL CLEANING SOLUTIONS:

A proper pre-spray needs to be selected and applied to the surface being cleaned. A rinse or detergent of neutral

pH (6 to 10pH) needs to be used with your ENDEAVOR to prevent premature wear of pump seals and related

components. Damage caused by the use of improper chemicals is not covered under warranty. Please consult

with your local distributor for recommended chemicals.

MAINTENANCE OF THE ENDEAVOR:

To ensure a long lasting life and optimum performance, certain maintenance procedures must be performed on a

regular basis.

DAILY:

Flush the plumbing system with clean fresh water at the end of the day.

Run the vacuum motor for 30 seconds before putting away the ENDEAVOR.

Rinse out the Recovery tank and clean filters after every use.

MONTHLY:

Use a flushing agent through the machine's plumbing to dissolve mineral and chemical build up.

GENERAL:

The exterior may be cleaned with any standard all-purpose detergent. You may protect it with auto interior

polish designed for vinyl or plastic.

Quick disconnects, wheels, casters, and regulators can be lubricated with an all-purpose silicone lubricant

spray.