- ページ 5

バイクアクセサリー AltRider R117-X-1001のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。AltRider R117-X-1001 6 ページ。 Crash upper bars for bmw r 1200 gsw 2017+

Reinstall the beak and side plastics (reverse steps 1-5)

Assemble each clamp. Add a drop of thread locker to the last few threads of

each M6 screw.

Place the top section of the clamp in between the upper and lower bars.

Next mate the bottom section of the clamp against the top and start

threading the rear two (2) M6 x 35mm bolts and washers. Then move to the

front two (2)

NOTE: bars may not line up dead center with holes in clamps. If this hap-

pens simply leverage on the bar so it lines up properly before starting the

threads to avoid cross-threading. Once all (4) bolts are started, torque them

to 10 nm in a criss-cross pattern providing equal compression.

BMW R 1200 GS W

Upper Crash Bars

Hold your upper bars in place while you start threading the (4) M6 x 35 mm

fasteners and washers. Add thread locker to each fastener, do not tighten all the

way. (Bracket may differ slightly from picture depending on model).

Installation Instructions

ALWAYS start rear bolts

1st because they are

"blind" and accessing

them first is the easiest.