ページを印刷する
Improper pH value or
does not turn on ORP
lamp.
Displaying E-6
Water leakage coming
out from outlet without
process operation.
Error codes can be canceled by pressing the Continuance Process button. The E-6
code cannot be reset in this manner.
● SPECIFICATION:
Machine designation
Model name
Dimensions
Power rating
Power Current
Operating temp
Operating humidity
Supply water quality
Supply water temp.
Acceptable water pressure
Electrolyze method
Operation hours
Process capacity
Electrode life
Cleaning
The water flow volume is too high.
Low salt water concentration
Trouble with Float switch
A clog has developed in the magnetic
valve located inside the unit.
Strong electrolysis water processor
ALTRON･AL-761N
281(W) x 218(D) x 394(H) mm around 10.5Kg
AC 100V 50/60Hz
3.2 A
0 ～ 40 ℃ (Does not allow for frozen condition)
0 ～ 85%RH
Tap water quality.
0 ～ 40℃
0.1 ～ 0.59Mpa (1 ～ 6 Kgf/cm
Continuous flow water electrolyzer with membrane
Maximum of 8 hours.
Approximately. 1 liter per minute both acidic and alkaline.
Around 2,000 hours but dependent upon
water characteristics, such as water
hardness.
Automated cleaning process initiated for each 2 hours of
use by changing electrode polarities.
18
Adjust the water inlet volume.
Remake the electrolysis water agent
with a higher level of salt.
Contact your agent.
Contact your agent.
2
)