- ページ 16

産業機器 Altronic 6715 DのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Altronic 6715 D 20 ページ。 Coaxial load resistor

PERSONNEL WORKING ON THIS LOAD MUST BE

CONSIDERED SKILLED AS DEFINED BY

BEFORE PERFORMING ANY MAINTENANCE:

DISCONNECT POWER AND ALLOW MOTOR TO COME TO A

FULL STOP.

DISCONNECT RF CONNECTOR ASSEMBLY AND LOCK OUT

TRANSMITTER OPERATING CONTROLS.

DISCONNECT TRANSMITTER INTERLOCK LINE.

FAILURE TO FOLLOW THESE DIRECTIONS

MAY CAUSE FATAL ELECTRICAL SHOCK!

5-1. Cleaning. The enclosure of the Model 6715D is finished with an acrylic finish or other

durable coating system. It should be cleaned with a neutral plastic and glass cleaner such

as Windex or Glass Plus. The RF connector should be cleaned with a non-residue contact

cleaner. Remove dirt accumulations from the fan and motor by vacuuming. Do not use

solvents or an air jet, as these can damage the motor. Remove dirt and dust accumulations

from the grills and resistor assembly with an air jet and a soft brush.

5-2.

The fan pillow blocks, if used, are lubricated at the factory with quality lithium-

based high temperature grease. Each pillow-block assembly has a bearing which must be lubricated

periodically

with ordinary lithium-based grease designed for ball-bearing lubrication. The motors

are factory lubricated and are not designed to be lubricated in the field except under severe

conditions.

5-3. RF Circuit. The RF circuit does not require any periodic maintenance and the only repairs

possible are the replacement of parts in the connector, quick-step or support portions of the

resistor assembly or the replacement of resistors.

The resistors are hard, brittle ceramic material. It is very important to

avoid impact and excessive force when installing or removing them.

6715D/Rev. Jul.2020

SECTION V

MAINTENANCE

WARNING

EN60215 SECTION 3.1 AND APPENDIX D

CAUTION!

Page 16

Altronic Research Inc.