- ページ 8

産業機器 Altronic 6715 DのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Altronic 6715 D 20 ページ。 Coaxial load resistor

This handbook was prepared for technical personnel as an aid in understanding and

performing installation, service and maintenance procedures for the Digital UHF

OMEGALINE

skilled if they have the necessary knowledge and practical experience of electrical and

radio engineering to appreciate the various hazards that can arise from working on radio

transmitters, and to take appropriate precautions to ensure the safety of personnel.

DESCRIPTION AND LEADING PARTICULARS

1-1. Purpose and Application of Equipment. The OMEGALINE ® Model 6715D Coaxial

Load is designed to safely dissipate a maximum of 15,000 watts of electrical energy over

the UHF frequency range.

1-2. Equipment Supplied. The Model 6715D Coaxial Load is supplied with standard RF

connectors. Their designations are:

3-1/8" EIA Swivel flange:

3-1/8" Unflanged flush:

3-1/8" Unflanged recessed:

The standard power supply voltages and their designators after the Model # are:

-110: 110-120VAC, single phase, 50/60 Hz

-230: 208-230VAC, single phase, 50/60 Hz

1-3. Equipment Required But Not Supplied. The Model 6715D Coaxial Load is complete as

supplied, but the user must furnish AC Mains input, RF input, interlock control cable and

ground cable appropriate to each installation.

1-4. General Description. The Model 6715D Coaxial Load is enclosed in a single aluminum

case which is painted with a durable acrylic finish. Power connection is made through an

IEC connector on the rear panel of the enclosure. This panel also contains a 4-screw barrier

terminal strip for connection of the interlock circuit and a 1/4-20 UNC-2B stud for

attachment of the ground. The RF connector is located in the center of the top panel.

assembly capable of dissipating 15,000 watts of applied electrical energy at sea level at

UHF band frequencies with a maximum VSWR of 1.15 to 1. No provisions are made for

tuning the resistor assembly and all operating controls relate to the operation of the blower

assembly. The blower control circuit consists of three switches wired in parallel to control

the blower motor contactor. Power is supplied to this contactor and to the "Blower On"

lamp whenever the equipment is attached to the correct power supply and the main power

6715D/Rev. Jul.2020

INTRODUCTION

Model 6715D Air-Cooled Coaxial Load. Personnel are considered to be

SECTION I

Model # 6715DE3

Model # 6715DF3

Model # 6715DR3

The Model 6715D contains a 50 ohm non-reactive resistor

Page 8

Altronic Research Inc.