- ページ 3

水ポンプ FiTech 50019のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。FiTech 50019 6 ページ。 Go fuel in-tank retrofit kit

Caution: Wear eye protection and ensure tank is free of

combustible fumes!! Have a radiator shop boil out the

tank.

If installing into Fuel Cell with 12 Bolt Flange already drilled

skip to Installing the C-Ring on next page.

Drilling the hole:

1. The In-Tank assembly must be installed into the top side of the fuel tank.

2. Before beginning to cut the 4 1/4" diameter hole, determine a location to drill the

hole in a central position on the fuel tank. Use the C-ring to help choose the

location. Try to find a flat area of the tank. If this is not possible due to ribs in the

tank, the supplied thick foam gasket will be required for the installation.

3. In selecting your hole location, be

sure to avoid the stock fuel level

sending unit assembly and stock

fuel pump pickup.

4. With the C-ring in position, mark a

spot in the center of the ring.

Using a scribe, you can scribe a

circle around the inside of the C-

ring and then measure from the

scribed line to find the center

point.

5. Now, you are ready to begin your

cut, drill a 1⁄4" pilot hole in the

center of the X spot. (Figure 1)

6. Then using a slow speed drill with

a 4 1/4" hole saw, cut a hole in the

tank. (Figure 2)

be sharp once hole is cut through

the fuel tank.

7. Remove the cut piece and use a

file to deburr the sharp edges.

Caution edges will

Figure 1

Figure 2