- ページ 15

ドローン dji AGRAS MG-1のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。dji AGRAS MG-1 19 ページ。
dji AGRAS MG-1 にも：ユーザーマニュアル (3 ページ)

Refer to the table below for Height LED descriptions. (The bottom of the Height LED on the panel is LED1 and

the top is LED4.)

LED1 LED2 LED3 LED4

4. Using Smart Operation Mode

Ensure that the Flight Mode Switch on the remote controller is toggled to the "P" position

and a strong GPS signal is present, then toggle the Operation Mode Switch to the "S"

position to enable Smart Operation Mode. The aircraft will align with the line between

Point A and Point B with its heading pointing toward Point B.

5. Start the Operation

a. Press the Back Left Button C1 and Back Right Button C2 on the remote controller

simultaneously to have the aircraft traverse from Point B to L1 (R1). The aircraft will

then hover at Point L1 (R1) and wait for further commands.

b. Enable Continuous Smart Operation Mode by pressing and holding the Back Left Button C1 and Back Right

Button C2 for 2 to 4 seconds when the aircraft is hovering at any given turning point. The aircraft will follow the

square zig zag route continuously. To exit Continuous Smart Operation Mode, press the Back Left Button C1

and Back Right Button C2 and hold for 2 to 4 seconds. The aircraft will fly to the next turning point and hover.

Use the control sticks to control the aircraft to avoid obstacles when it is in operation, however, the heading of the

aircraft cannot be adjusted. The aircraft will resume to operation route automatically upon releasing the control sticks.

Release the control sticks only after the aircraft is far away from the obstacle, or else the aircraft may still hit obstacles

when it is resuming its operation route.

If you press Button A or B when in operation, data for Point A and B of the current route will be erased and the aircraft

will hover in place.

Manual and Manual Plus Operation

Refer to the User Manual for details about the two operation modes.

More Function

Operation Resumption

Refer to the User Manual for details.

Data not used. Enter Manual Operation Mode to adjust spraying distance to

within the working range (2 - 3.5 m) and return to Smart Operation Mode.

Invalid data, adjust the spraying distance to within the detection range

(1.5 - 7 m). Or abnormal radar cable connection, check the connection.

System Data Protection

AGRAS MG-1

Spraying Distance

< 2 m

2 - 2.5 m

2.5 - 3 m

3 - 3.5 m

3.5 - 4 m

4 - 4.5 m

4.5 - 5 m

> 5 m

Empty Tank Warning

Quick Start Guide