- ページ 15

ドローン dji AGRAS MG-1SのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。dji AGRAS MG-1S 20 ページ。 Spreading systems
dji AGRAS MG-1S にも：取扱説明書 (17 ページ)

ページを印刷する

Using Intelligent Operation Planning System

The remote controller equips a highlighted screen with a built-in Android system, which can run the DJI MG

app. Measure operation area and obstacles, configure waypoints, and other settings via the intelligent operation

planning system built-in the app, and the app will produce a flight route according to the settings. The aircraft can

operate automatically following the flight route when it is in F-mode.

Planning Flight Routes

Ensure that the aircraft is powered off when planning your flight route.

DJI MG

APP

Turn on the remote

controller

Go to DJI MG app

Walk alongside the

boundary

Tap "Add Waypoint C2"

at turning points

Tap "End

Measurement"

The calibration point is used to rectify the bias of the ﬂight route caused by the positioning difference between

the remote controller and aircraft. Choose a ﬁxed reference point for calibration like a metal peg or obvious

marker that is easy to identify for bias rectiﬁcation when executing the same task.

Starting Task

Put the aircraft to the

calibration point

Tap "Rectify Offset"

Be sure to take off in open areas.

The task will be cancelled automatically if motors are started before starting the task. You need to re-call

the task in the task list.

The aircraft will hover at the ending point of the ﬂight route after the task is completed.

Tap "Field Plan"

Tap "Start Obstacle

Measurement C1" near

the obstacle*

Adjusting the flight

route: route angle,

line spacing, and

shrink distance

Power it on

Tap "Start Task"

AGRAS MG-1S

Satellite count ≥ 10

Positioning accuracy:

~ 2m

Walk alongside the

obstacle and tap "Add

Waypoint C2" to add

several waypoints*

Walk to the location of

the calibration point. Tap

"Add Calibration Point

C3"

*If any obstacle exists in the operating area.

Toggle the Flight Mode

Switch to F-mode

"Slide to Execute"

Quick Start Guide

Tap "Start Measuring"

Tap "End Obstacle

Measurement C1"*

Save the task

Select from the "Task

List" and "Use Task"