- ページ 4

インバーター AIMS Power PWRINV10KW12VのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AIMS Power PWRINV10KW12V 13 ページ。 Dc to ac power inverter

V 2.0

A: Fan

REAR VIEW

B: Battery terminal (-)

B: Battery terminal (+)

C: Chassis grounding

A: Fan:

Do not obstruct, allow at least 12 inches for air flow.

B: Battery terminals:

Connect to 12V, or 24V, or 36V, or 48V (depending on inverter model) battery

(s) or other DC power source. "+" is positive & " - " is negative. Reverse polarity connection will blow

internal fuse and may damage inverter permanently. Make sure you check your input voltage and do

not REVERSE POLARITY! This will void the warranty.

C: Chassis ground lug: Connect to earth ground or to vehicle chassis using #8 AWG wire.

Warning! Operation of the inverter without a proper ground connection may result in an electrical

safety hazard.

If you would like to quickly hook-up the power inverter and check its performance before moving

forward with your installation, please follow these guidelines:

1. Unpack and inspect the power inverter, check to see that the power switch is in the OFF position.

2. Before you connect the battery cables, make sure the power switch is in the off position. Connect

Red (+) battery cable to Red (+) inverter terminal. Connect Black (-) battery cable to Black (-) inverter

terminal. Connect Red (+) battery cable to Red (+) battery terminal. Connect Black (-) battery cable to

Black (-) battery terminal. Alligator clamp cables may be used but only to connect to the battery. Do not

use clamps on inverter terminals. Alligator clamps are not a permanent solution. You may see a spark

during connection. Do not reverse the polarity. This may damage the inverter and void warranty.

Caution! Loosely tightened connectors result in excessive voltage drop and may cause overheated wires

and melted insulation. Reverse polarity connection will blow a fuse in inverter and may permanently

damage the inverter. Damage caused by reverse polarity connection is not covered by our warranty.

Warning! You may observe a spark when you make this connection since current may flow to charge

capacitors in the power inverter. Do not make this connection in the presence of flammable fumes, as

explosion or fire may result.