- ページ 4

インバーター AIMS Power PWRINV250012WのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AIMS Power PWRINV250012W 10 ページ。 Dc to ac power inverter

Battery Use

•

To avoid over-discharging your vehicle battery, we recommend running your engine for 10-20

minutes to recharge the vehicle's battery if battery voltage drops <11V.

•

To properly size your battery, use the following formula: Volts * Amps = Watts or Watts/Volts

= Amps. Example: 1000 watt inverter / 12 volts DC = 83.3 DC amps. In this example, you will

need 83.3 amps to power a 1000 watt load for 1 hour. If you need to power 1000 watts for 2

hours you will need 83.3 * 2 = 166.66 DC amps available. A 100 amp hour battery will give

you 100 amps / 166.66 = .6 hours so you will need two batteries if using 100 amp battery.

This is if you fully deplete your batteries. We do NOT recommend fully depleting your

batteries. This is just an example. Your power requirements may be different.

•

If you choose to use a female 12 Volt DC adapter for your inverter or to the inverter make

sure wire size is correct.

•

IF YOU CONNECT THE WIRES TO THE INCORRECT TERMINALS, YOU WILL REVERSE THE

POLARITY AND DAMAGE THE INVERTER.

•

REVERSED POLAR ITY WILL INSTANTLY VOID THE WARRANTY OF YOUR INVERTER, SO BE

CAREFUL TO CONNECT YOUR INPUT WIRES PROPEPLY.

•

If you choose to operate a battery charger to replenish your battery's voltage, be sure to

check with charger manufacture before damaging the charger.

•

CONNECTING THE INVERTER'S DC INPUT TO A BATTERY CHARGER WILL VOID THE WARRANTY,

AND MAY DAMAGE THE INVERTER.

•

Make sure that the battery voltage does not exceed 15 volts DC.

•

CONNECTING THE INVERTER TO A DC POWER SOURCE GREATER THAN 15 VDC WILL VOID

THE WARRANTY, AND MAY DAMAGE THE INVERTER.

Cables

We recommend that you refrain from using battery cables longer than 12 feet

between the DC power source and the DC input of the inverter. Longer battery cables

on the DC input will create a voltage drop which results in a reduction of efficiency

and output. If you require more than 12 feet, use a bigger cable. We recommend

using an extension cord between the AC output and AC appliance. You may use up to

100ft, high quality extension cord. A longer cord may result in reduced output. See

Specifications chart for recommended battery cable size.

These inverters included a digital display to monitor input DC volts, DC amps, AC output watts and

error codes.

A display selector button allows the user to advance the display readout to the next readout. The