- ページ 12

ドローン dji Zenmuse H3-3DのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。dji Zenmuse H3-3D 18 ページ。

ZENMUSE H3-3D User Manual

1. Solder the Video Signal/GND cables to your wireless video transmission module (air system).

2. Plug the gimbal video signal cable into the GCU video signal port.

Ensure the wireless video transmission unit is connected to the GCU before powering on the aircraft.

Use of a standard gimbal video signal cable is recommended. Make sure you solder the

gimbal video signal cable to the wireless video transmission module firmly. Insulate all the

cables to prevent short circuiting.

The GCU does not provide power to the wireless transmission module. Refer to the wireless

video transmission module manual for details on the power supply connection.

The diagram below shows the how video signal flows from the camera to the gimbal.

Should errors occur, examine each step to locate the source of the problem.

Camera

Video Port

Monitor

AV Input

Gimbal

AV Signal

Camera Interface

Wireless Video

Transmission Module

AV Signal

Ground System

GCU

AV Signal

8-Pin cable

Wireless Video

Transmission Module

Wireless Signal

Air System

5.8G/2.4G/1.2G

AV Signal

Gimbal Video

Signal Cable

Supplied by user