- ページ 11

クワッドコプター dji Agras MG-1PのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。dji Agras MG-1P 12 ページ。 Spreading systems
dji Agras MG-1P にも：取扱説明書 (17 ページ)

AC Power Adapter

Model

Voltage

Rated Power

FCC ComplianceNotice

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) This device must accept any interference

received,including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

—Reorient or relocate thereceiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information

Aircraft complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to

avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna

shall not be less than 20cm during normal operation.

For Remote Controller (model GL300N),SAR tests are conducted using standard operating positions accepted

by the FCC with the device transmitting at its highest certified power level in all tested frequency bands,

although the SAR is determined at the highest certified power level, the actual SAR level of the device while

operating can be well below the maximum value. Before a new model is a available for sale to the public, it

must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC, Tests

for each product are performed in positions and locations as required by the FCC.

A14-057N1A

17.4 V

57 W