- ページ 6

クワッドコプター dji AGRAS MG-1SのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。dji AGRAS MG-1S 20 ページ。 Spreading systems
dji AGRAS MG-1S にも：取扱説明書 (17 ページ)

AGRAS MG-1S

Quick Start Guide

Mounting the Spray Tank

1. Connect the sprinkler kits to the spray tank.

Remove the nuts on the left and right delivery pump outlets and pull the white hose on the T connector

through the nut to the left outlet. Pull the black hose on the T connector through the nut to the right outlet,

then tighten both nuts using an appropriate wrench. Be sure to securely tighten the nuts to avoid liquid

leakage.

Remove the nut on the T connector then pull the white (or black) hose with a sprinkler through the nut to

the T connector with a white (or black) hose. Tighten the nut using an appropriate wrench.

Insert the two T connectors of the two sprinkler kits into the slots between the two delivery pumps. Note

that the T connector with a white hose should be under the one with a black hose.

White Hose

2. Prepare hose clamps B and M4×8 screws to fix the hoses to both sides on top of the spray tank.

Open hose clamps B to an appropriate angle gently. DO NOT over-stretch the clamps to avoid damage.

Clip the clamps around a white hose (outer position) and a black hose (inner position) at positions that need

to be fixed. Ensure the flat side of the clamp is close to the spray tank, then tighten the M4×8 screw.

3. Remove the cover of the spray tank. Looking from the rear of the aicraft, pull the hoses on both sides through

the space between the two tubes of the landing gear leg with the mouth of the tank facing to the right side of

the aircraft.

4. Lift the spray tank and pull the mouth of the tank through the space between the two tubes of the right landing

gear leg.

Black Hose

White Hose