- ページ 5

クワッドコプター dji FlameWheel 450のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。dji FlameWheel 450 9 ページ。
dji FlameWheel 450 にも：ユーザーマニュアル (8 ページ)

Tools Needed

Tools

2.0mm Hex Wrench

Screw Glue

Nylon Cable Tie, Scissors, Diagonal Cutting Pliers

Foam Double Sided Adhesive Tape

Soldering-iron & wires

The size of the assembly hole is shown below.

The screw size is M3. Mount the motors using appropriate screws.

Note the thread depth and the size of the screws. Using screws that are too long or

too large may damage the motor.

28.2 mm

Use

For frame and motors installation.

For fastening screws.

For binding devices and wires.

For fixing receiver, controller and

other modules.

For connecting ESCs'power

cables to bottom board.

4×M3 Thread depth 3mm

16 mm