- ページ 8

クワッドコプター dji Inspire 1 ProのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。dji Inspire 1 Pro 11 ページ。
dji Inspire 1 Pro にも：クイック・スタート・マニュアル (10 ページ), クイック・スタート・マニュアル (11 ページ), ユーザーマニュアル (10 ページ)

ページを印刷する

8. Mounting the Gimbal and Camera

Ensure to power off the aircraft.

Rotate the Gimbal Lock to the unlocked position.

Align the key on the damping plate with the slot on the gimbal's pan motor.

While aligning the white lines on the Gimbal Connector and Gimbal Lock,

insert the Gimbal Connector.

Rotate the Gimbal Lock to the locked position.

Gimbal Lock

Mounting Place

Gimbal Connector

9. Preparing for Flight

Place the aircraft on a flat surface, in an open space, with the back facing you.

Move the Flight Mode Switch to the right to select P mode. ( P mode is Positioning mode, A mode

is ATTI mode, and the F mode is Function mode. )

Power on the remote controller.

Power on the aircraft and wait for the self-check to complete. Do not move the aircraft during the

self-check.

Ensure the remote controller is linked to the aircraft before flight. Re-link the remote controller to the

aircraft if it fails to connect. Refer to the INSPIRE 1 PRO User Manual on how to link.

Ensure the remote controller and your mobile device are connected with a USB cable. Launch the

DJI GO app when connecting to the aircraft for the first time, and follow the instructions within the app.

Launch the DJI GO app and tap "Camera". Ensure the aircraft is functioning normally by completing

the Checklist.Beginner Mode is enabled by default when you launch the DJI GO app for the first

time. The aircraft's altitude and flight distance is restricted when flying in Beginner Mode. We

recommend you fly in Beginner Mode when using the aircraft for the first time. You may disable

Beginner Mode in the settings page of the DJI GO app.

Calibrate the compass by tapping the Aircraft Status Bar in the app and selecting "Calibrate". Then

follow the on-screen instructions.

Installing the 1345T Propellers: Attach the propellers with white arrows onto the motors with white arrows,

and attach the propellers with red arrows onto the motors with red arrows. To attach the propeller, rotate

the propeller lock to align the arrows on the mounting plate and propeller lock. Attach the propeller and

then rotate the propeller lock until the arrows on the propeller and propeller lock are aligned.

When not in P mode, the Inspire 1 Pro will only maintain altitude, not position, and will drift

●

with wind or user inputs. Return to Home is not available in F mode.

Ensure the aircraft is fully charged when use with the Zenmuse X5, as power suddenly

●

drops may bring dangerous.

10. Remote Controller Operation

The remote controller is by default set to Mode 2 ( throttle controlled by the left-hand stick ).

Adjust the tilt angle of camera by using the Gimbal Dial.

Left Stick

You can set the remote controller to different modes using the DJI GO app.

●

Right Stick

DJI GO

App

Gimbal Dial