- ページ 15

スピーカー 1 Sound LCC44のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。1 Sound LCC44 16 ページ。

Figure 34. Releasing the pan lock bolt.

• Use a 5 mm Hex wrench to loosen the pan lock bolt on the top

of the Wall Mount Bracket.

• Rotate the enclosure to the left to allow clear access to the tilt

lock bolt.

Figure 35. Locking the tilt angle.

• Adjust the tilt of the enclosure to the required angle and keep

a firm hold on it.

• Firmly tighten the tilt lock bolt using a 5 mm Hex wrench.

• Release the speaker enclosure and assure that the chosen

angle remains firm.

| 3 - INSTALLING LCC44/LCC84 ON A WALL MOUNT BRACKET

Fixing the pan angle

With the tilt angle locked, setting the pan angle is as simple as turning the

LCC44 or LCC84 enclosure to the desired angle and locking it in place

by tightening the pan lock bolt.

Note: The panning range of the Wall Mount Bracket is ±90° from

the center. However, this range may be limited on one or both

sides by the mounting surface, due to the width of the rear panel

of the LCC44 or LCC84 enclosure. If the Bracket is installed on

a flat wall, the mount will allow approximately ±65° of panning

range, depending on the tilt angle.

Figure 36. Panning range limit on a continuous wall,

view from above.

• Rotate the enclosure to the desired horizontal orientation.

Figure 37. Tightening the bolt to lock the pan angle.

• Using a 5 mm hex wrench, firmly tighten the pan lock bolt until

the enclosure is locked in the desired position.