- ページ 6

クワッドコプター dji Spreading System 2.0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。dji Spreading System 2.0 17 ページ。 Spreading systems

Route Operation Mode

After starting an operation, the aircraft ascends to an altitude of 4 meters and the spinner disk

spins. When the aircraft reaches the route starting point, the hopper gate opens according to the

set value and the aircraft flies along the route and spreads material automatically. Spreading cannot

be started or stopped manually.

The operation resumption function can be used during operation. Once the operation is paused,

the hopper gate closes automatically to stop spreading while the spinner disk is still spinning. After

operation is resumed, the aircraft returns to the breakpoint or projection point and continues spreading.

A-B Route Operation Mode

After the aircraft enters A-B Route Operation Mode, the spinner disk spins. When the aircraft reaches the

first turning point, the hopper gate opens according to the set value and the aircraft flies along the route

and spreads material automatically. Spreading cannot be started or stopped manually.

The operation resumption function can be used during operation. Once the operation is paused,

the hopper gate closes automatically to stop spreading while the spinner disk is still spinning.

After operation is resumed, the aircraft returns to the breakpoint or projection point and continues

spreading.

Manual Plus Operation Mode

Switch to M+ after the aircraft takes off. Press the Spray button to start the spinner disk. The hopper

gate opens according to the set value and the aircraft spreads material automatically once it has

begun flying.

Manual Operation Mode

Switch to M after the aircraft takes off. Use the Spray button on the remote controller to start or stop

spreading.

In all operation modes except Manual Operation Mode:

• When the aircraft flies forward or backward, the hopper gate opens automatically to start

spreading.

• When the aircraft flies left or right, the hopper gate closes automatically to stop spreading

while the spinner disk continues to spin.

Spreading System Calibration

When to Calibrate

The Spreading System has been calibrated before delivery. There is no need to calibrate it before

using for the first time. Calibration is required in any of the following cases:

• The hopper gate cannot fully open or close.

• The material delivery rate is different from the desired value.

• The app incorrectly displays empty tank warnings.

Calibration Procedure

In the app, enter Operation View. Tap

Spreading System Settings. Wait until the app indicates calibration is complete. If calibration fails,

try again.

at the top of the screen, then tap Calibration in