- ページ 10
換気フード ARTHUR MARTIN AFB9571MXのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ARTHUR MARTIN AFB9571MX 18 ページ。
ページを印刷する10
CONTROLS
The hood is fitted with a control panel with
aspiration speed selection control and a
light switch to control cooking area lights.
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood
suction is switched on for 5 minutes prior
to cooking and to leave in operation
during cooking and for another 15 minutes
approximately after terminating cooking.
The control switches are located on the
unit's front panel:
1 1
1 2
1 Motor ON/OFF button
By pressing the button, the hood starts
at speed 1.
Pressing the button (OFF) while the
hood is in function turns the latter off.
2 Speed increase button
By pressing the button, the hood starts
at speed 1.
Pressing the button (while the hood is
on) modifies the motor speed:
Speed 1: the number "1" appears on
the display
Speed 2: the number "2" appears on
the display
Speed 3: the number "3" appears on
the display
High-speed: the number "4" appears
(flashing) on the display
The high-speed function is regulated
by a timer. The standard time setting is
5', at the end of which the hood adjusts
to speed 2.
Press button 2 to deactivate this
function before the set time expires;
the hood will adjust to speed 1. Press
button 1 to turn the hood off.
3 Lights ON/OFF button
4 Speed timer button
5 Display
1 4
1 3
1 4
Speed timer button
Press button 4 to activate the speed
timer; the hood turns off once the set time
expires.
The timer functions in the following way:
Speed 1 - 20 minutes (the number "1"
•
and a small flashing LED light appear
on the display)
•
Speed 2 - 15 minutes (the number "2"
and a small flashing LED light appear
on the display)
Speed 3 - 10 minutes (the number "3"
•
and a small flashing LED light appear
on the display)
•
High-speed - 5 minutes (the number
"4" and a small flashing LED light
appear on the display)
Press button 1 or button 4 to turn
the hood off while the speed timer is in
function; by pressing button 2 , the hood
returns to the set speed.
Saturation indicator of the grea-
se filter
After 80 hours of operation, the display
shows alternately the set speed and the
letter "F".
Saturation indicator of the char-
coal filter
After 320 hours of operation, the display
shows alternately the set speed and the
letter "C".
Reset of saturation indicator
In order to reset the saturation indicator,
switch on the hood then press and hold
button 1 for about 3 seconds.
Perform filter maintenance as
recommended in this manual.
In the event that both indicators of filter
saturation "F" and "C" start flashing,
proceed with the reset twice.
The saturation indicator of the charcoal
filter is not normally active and if the hood
is used in the recirculation mode, it must
be activated manually the first time.