- ページ 6

カメラアクセサリー dji Osmo Mobile 4のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。dji Osmo Mobile 4 16 ページ。

Mode

Transmitter Power（EIRP）

Operation Frequency

Battery Type

Capacity

Energy

Voltage

Charging Temperature

Operating Temperature

Charging Time

Operating Time

Compliance Information

FCC Compliance Notice

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) This device must accept

any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information

7.72 inch Thickness:6.9-10 mm Width: 62-88

Bluetooth Low Energy 5.0

≤4 dbm

2.400-2.4835 GHz

18650 Li-ion

2450 mAh

17.64 Wh

7.2 V

5° to 40° C

0° to 40° C

2.5 hours (Measured with a 10W charger)

15 hours (Under ideal conditions with the

gimbal fully balanced)