- ページ 11
カメラアクセサリー dji Zenmuse H3-2DのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。dji Zenmuse H3-2D 16 ページ。
ページを印刷する
STEP3. Video Signal Transmission
A wireless video transmission module is necessary for video signal accessing remotely.
Wireless Video
Transmission Module
Power
Air End
Video Signal
GND
1.
Respectively solder the Video Signal/GND cables to wireless video transmission module (Air End).
2.
Plug the gimbal video signal cable head into the GCU Video Signal Port.
Notes
(1)
Make sure to connect
(2)
The standard gimbal video signal cable is recommended. Make sure you solder the gimbal video signal
cable to the wireless video transmission unit correctly. And ensure the cables are insulated, to prevent
from short circuit.
Disconnected
Video Signal Cable(AV)
GND Cable
(3)
Please refer to your wireless vedio transmitter module manual to supply power,
since GCU can't supply power for it.
Tips:
(1)
Following diagram shows how video signal transit when gimbal working.
(2)
If video signal access fails, please check each step.
Camera
System Port
Monitor
AV input
©2013 DJI Innovations. All Rights Reserved.
Gimbal Video Signal Cable
Extra power supply
Disconnected
Video Signal(Yellow:AV)
GND(Black: )
Wireless
Video Transmission Unit to GCU first, then power on.
Gimbal
AV signal
Camera Interface
Wireless video
transmission module
AV signal
Ground end
Video Signal Port
GCU
AV signal
G8
8-Pins cable
Wireless video
transmission module
Wireless signal
5.8G/2.4G/1.2G
Self-prepared by user
AV signal
Gimbal Video
Signal Cable
Air end
11