- ページ 3

リモコン dji DT7のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。dji DT7 7 ページ。 2.4g rc system
dji DT7 にも：ユーザーマニュアル (5 ページ)

ページを印刷する

Remote controller Power LED Indicator Status Information

Power LED Indicator

Important: The remote controller will power off automatically when battery voltage drops below 4V. Land and

change batteries as soon as possible when the low voltage alert occurs to avoid loss of control during flight.

Connecting the DR16 Receiver to the Flight Control System

The DR16 Receiver is designed to be used with the below flight control system. Connect the DR16 receiver to the

correct port on the main controller in the flight control system using a 3-Pin cable, then select the

type in the Assistant software.

Flight Control

System

Port on the Main

Controller

Linking the DT7&DR16

1. Power on the main controller and the DR16 receiver.

2. Turn on the remote controller and place the remote controller 0.5m~1m from the receiver.

3. Poke the link button with a thin object and hold it until the LED indicator on the receiver blinks red, then release

it.

4. When the LED indicator becomes solid green, the link between the DT7 remote controller and the DR16 receiver

has been successfully established.

The LED Indicator Status of DR16

LED Indicator

Usages of the RC SYSTEM Assistant software

The RC SYSTEM assistant software is used to configure the DT7 remote controller, upgrade its firmware, select the

sticks mode and calibrate the sticks.

Download & Installation & Connection

1. Download the driver and RC SYSTEM Assistant software, then install the diver and software on your PC.

2. Turn on the remote controller and connect it to the PC by Micro-USB cable.

- 3 -

Sound

Remote Controller Status

None

Normal

B-B-B......

Low voltage (at 4V-4.3V). Replace the batteries immediately

Alarm will sound after 15 minutes without activity. It will stop once you

B--B--B......

start using the remote controller.

NAZA-M Lite

NAZA-M

Status

The remote controller is linked with the receiver successfully

The remote controller is turned off and there is no 2.4GHz signal around

The receiver is ready for linking

There is 2.4GHz signal around but the remote controller is not linked with the

receiver

NAZA-M V2

WooKong-M

D-BUS

receiver