ページを印刷する
1. Charging the Smart Controller
It takes roughly 2 hours and 15 minutes to fully charge the Smart
Controller using the standard USB charger.
Power Outlet
(100 - 240 V)
Please use the official USB charger to charge the Smart Controller. When a standard USB charger is not
available, it is recommended to use an FCC / CE certified USB charger rated 12 V / 2 A.
• Please recharge the battery at least every three months to prevent over discharging - the battery will deplete
when stored for an extended period.
2. Mounting the WB37 Intelligent Battery
Press and hold the battery release button.
1
Insert the Intelligent Battery into the battery compartment. Make sure the bottom of the
2
battery is aligned to the marking line in the compartment.
Push the battery to the bottom.
3
To remove the Intelligent Battery, press and hold the battery release button, then push the battery
upward.
Refer to the BS60 Intelligent Battery Station User Guide for Intelligent Battery charging details.
3. Checking the Battery Level and Turning On
Check the internal battery level according to the
Battery Level LEDs. Press the power button once to
check it while turned off.
Press the power button once, press again and hold for
a few seconds to turn on/off the Smart Controller.
Please refer to the user manual for more details about checking the internal and external battery levels.
When using external WB37 Intelligent Battery, it is still necessary to make sure that the internal battery has
some power. Otherwise, the Smart Controller cannot be turned on.
USB charger
USB-C Cable
1
3
2
Low
High
3