- ページ 15

エアクリーナー Artico SY PA300のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Artico SY PA300 16 ページ。

ページを印刷する
Problem
The appliance
doesn't work
The airflow has
significantly
reduced
The fan speed does
not change to
automatic mode.
Poor performance
Too noisy
Possible cause
The filter cover is not closed properly Remove the filter cover and
Power plug is not connected to a
power supply.
The appliance is not turned on.
Filters packaging has not been
removed.
The air quality is good and
therefore the automatic mode
has been activated.
Sleep mode has started automatically,
the LED indicator turns off, while the
fan speed and noise level are also
reduced.
The Pre-filter is too dirty.
The filter has not been replaced.
Insufficient space and ventilation in
the surroundings.
The air quality sensor is humid, or
the ambient temperature is too high,
causing condensation on the
sensor.
The room area is too large.
The air inlet or outlet of the appliance
are blocked.
Filter's plastic packaging haven 't been
removed.
reinstall it.
Unplug and reconnect power.
Plug in the power and turn the air
purifier back on.
Filter's plastic packaging
should be removed before
use.
In automatic mode, the
appliance will automatically
adjust the fan speed to save
maximum energy.
Press the fan speed button and
choose the desired fan speed.
Please clean up the Pre-filter.
Replace with a new filter.
Make sure there is at least 15
inches (38 cm) of free space in all
directions around the purifier.
Make sure the air quality sensor
is clean and dry.
Use the air purifier in a smaller
room.
Clean the air inlet and outlet and
remove any obstructions.
The plastic packaging of the
filter must be removed before
use.
14
Possible solution