- ページ 10

デジタルカメラ dji Zenmuse X5のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。dji Zenmuse X5 18 ページ。 For inspire 1 pro
dji Zenmuse X5 にも：ユーザーマニュアル (17 ページ), ユーザーマニュアル (11 ページ), ユーザーマニュアル (18 ページ), マニュアル (11 ページ)

ZENMUSE X5 User Manual

Mounting the Zenmuse X5 to the Inspire 1

(Watch Video: http://www.dji.com/product/inspire-1/video)

Ensure the aircraft is installed with Landing Gear Risers.

1. Remove the two black dampers at the front.

2. Disconnect the 10-PIN cable and 8-PIN cable in order. Be careful not to damage the

gimbal cables.

3. Remove the other two black dampers.

4. Attach the new gimbal mounting plate as shown below. With their flat sides facing

outwards, align the rear mounting plates with the rear bracket's screw holes. Tighten the

screws with a screwdriver.

5. Connect the 8-PIN cable and 10-PIN cable in order.

6. Place the front mounting bracket to the front bracket with its grooved side facing inwards.

Adjust the 8-PIN cable and 10-PIN cable to avoid protrusion, and then tighten the screws.

Rear Mounting

Plate

Front Mounting

Plate

Mounting

Position