- ページ 2
ベビーアクセサリー Fitness Wise Holdings Jolly JumperのPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。Fitness Wise Holdings Jolly Jumper 2 ページ。
ページを印刷するOUR BEST TO YOU
We have assembled the best
components that money can buy
to make a safe, scientifically
'very
designed exerciser for the
important baby in your life':
Please follow carefully these - IF
CEILING HOOK USED
1. Pick spot where baby will be free
to maneuver 3 or 4 feet in all
directions.
2. Find ceiling joist by tapping with
knuckle. Mark spot where hook will
go - place piece of scotch tape
over spot to prevent cracking of
plaster.
3. Screw hook well into ceiling
joist.
4. Test hook with adult weight.
5. Hang spring up by looping link of
attached chain over hook. Chain is
for adjustment.
6. The location of a joist or other
heavy material is of the utmost
IMPORTANCE. Do not trust to thin
wood or wall board.
7. In summer the jumper can be
suspended from porch, rotary
clothesline or sturdy tree in the
garden.
8. Be sure to take it along on
picnics.
DOOR CLAMP
Another way to use your Jolly
Jumper is to suspend it from the
casement of your door with the
sturdy Door Clamp enclosed with
your
Jumper. (see insert No. 1) Be
sure there is a narrow ledge on
each side of the door when using
the clamp. The Clamp can be easily
put in the over lock position and
used on trees or rotary clotheslines,
thus giving the Jumper complete
portability.
I
Attach the clamp to the door
frame as illustrated.
SAFE
STURDY
SUPPORTS 50kgs
•
•
ASSEMBLY INSTRUCTIONS
2
Clip the spring section onto the
clamp.
Lay the saddle out flat with the
striped webbing out to the sides.
Put baby on the saddle and bring
the lower part of the saddle up
through the legs. Bring the left then
right flap over and attach to the
hook and pile fastening.
(Make sure this is tight to provide the
support needed to hold baby
upright and to keep baby's back
straight.)
Bring the flap down over the
hook and pile fastening and
dome.
MOVED EASILY
•
Attach the clips (attached to
webbing) to each end of the
bar.
Fasten the Jolly Jumper to spring
(which is already hanging from
hook or door clamp) by placing
the palm of your hand under the
base of the nylon bar and then lift
baby up to the spring and connect
the swivel snap to bar.
NO SCREWS OR NAILS
•
Adjust the height of the Jolly
Jumper so that baby's toes just
touch the floor. Use the chain
links to adjust height.
WARNING
It is advisable not to place the
Jumper near open stairways or
over concrete floors. Baby should
not be left unattended.
QUICKLY ATTACHED
•