- ページ 5

ラック＆スタンド Artillian 1UTVTBのPDF インストレーション＆オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Artillian 1UTVTB 8 ページ。 Artillian utv bed mounted tool bar

FEATURES

The Artillian UTV Bed Mounted Tool Bar allows for one or more Artillian ROPS Mounted Accessories to be

attached to the vehicle ROPS. Additional Tool Bars allow for additional accessories.

The innovation of the design is that any of the compatible accessories can be installed or removed from the Tool

Bar in seconds, without the use of tools.

One job may require a toolbox filled with various hand tools. Another might necessitate a tool rack holding

assorted long-handle yard tools or maybe a chainsaw mount and fuel can holder.

With the effortless installation and removal of each accessory, you won't waste any time setting up your UTV to

carry the specific tool required for the job!

ATTACHING ACCESSORIES:

1. Figure 1 shows an example of a toolbox installed

on a ROPS Mounted Tool Bar. Installation onto a

UTV Mounted Tool Bar is the same.

2. To install an accessory, have both cam levers

rotated UP, then place onto the Tool Bar. See fig.

3. To secure the accessory to the mounting bar,

rotate both cam levers DOWN until they cam over.

See fig. 3.

NOTE: The accessory can be locked to the Tool Bar by

inserting a padlock through the holes in the mounting bracket

where shown.

4. To remove an accessory, rotate both cam levers

UP and lift the unit off of the Tool Bar.

OPERATION

Due to the excessive vibrations generated by a UTV, the

UTV Bed Mounted Tool Bar fasteners may loosen up

over time. It is recommended that the fasteners are

checked and retightened, as required, regularly.

Depending on space availability on a given UTV Bed, a

second Tool Bar can be added to allow for even more

accessories to be attached at a time.

FEATURES AND OPERATION

Fig. 1 (example of attaching a tool box)

rotate both cam levers up

to install an accessory

Fig. 2 (cam lever in the open position)

padlock holes

rotate both cam levers down

to secure the accessory

Fig. 3 (cam lever in the closed position)

5 of 8