- ページ 6
圧着工具 Custom Crimp D100S SERIESのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Custom Crimp D100S SERIES 12 ページ。 Hydraulic hose crimper
Custom Crimp D100S SERIES にも： 取扱説明書 (13 ページ)
ページを印刷する
CRIMPING WITH STANDARD DIES
• Place the flat pressure plate in the bottom flange and select the
correct die set for the combination of hose and fitting to be
crimped. Refer to the hose and fitting manufacturer's
recommendation for the correct die set to use.
• Lubricate the contact surfaces of the die fingers and
compression cone thoroughly with the die lubricant furnished with
the crimper (EZCRIMP M).
Failure to lubricate the contact surfaces with the proper
lubricant will cause the dies to seize in the compression cone.
• Set the Micro-Crimp Adjuster to the setting recommended by the
hose and fitting manufacturer for the combination of hose and
fitting being crimped.
NOTE: The Metric Micro-Crimp Adjuster is a direct reading
micrometer. Add the setting on the micrometer to the closed
diameter of the die set to obtain the finished crimp diameter. For
example: With a 39mm die and the Micro-Crimp Adjuster set at
3 the finished crimp diameter would be 42mm
• Place the Compression Ring over the die set and align the fitting
to the correct position.
• Slowly bring the Pusher in contact with the Compression Ring
until the hose and fitting are held in position with a very light
pressure. Recheck the fitting for correct alignment.
• Continue to apply pressure until the white circumferential line on
the Micro-Crimp Sight Button just appears above the Micro-Crimp
Adjuster (See illustration on P 5) or the electric power unit shuts
off for the 101S crimper.
• Check the diameter of the finished crimp to be certain that it is
within the specifications of the hose and fitting manufacturer.
NOTE: Each die set has a limited range of diameters for
which it can be used. A "Rule of Thumb" is that if you can see
the notches on the die fingers under the Compression Ring
prior to crimping, you must select a larger die
size.
Page
6