- ページ 3
DJ機材 djpower V-4のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。djpower V-4 17 ページ。 Super spark machine
ページを印刷する•
During heating up and operation, the housing will be scalding hot. Do not touch.
•
The product is very hot during operation and it remains hot for a long time after operation has
stopped. Do not touch the product's nozzle.
•
Keep a minimum distance of 6.6 ft. (2 m) from the machine to the nearest human or flammable
material. The output spark from the nozzle must be in the air but not reaching any object. And mind
the falling residue after the spark.
•
Make sure that children, unauthorized people and animals do not obtain access to the machine.
•
The operation noise is lower than 105 dB without harm to ear. No need to wear ear protection when
close to the working machine.
•
Eye protection is always required when operate the machine closely.
1.5.2
Mounting and Rigging
•
When using outdoors, for best effects, please place it away from wet ground.
•
For safety reasons, we do not recommend mounting the product in any capacity. Operate the
product while it is on the ground only.
•
CAUTION: When transferring product from extreme temperature environments, (e.g. cold truck to
warm humid ballroom) condensation may form on the internal electronics of the product. To avoid
causing a failure, allow product to fully acclimate to the surrounding environment before connecting
it to power.
•
Do not mount the product on a flammable surface (linoleum, carpet, wood, paper, carton, plastic,
etc.).
•
Do not use in a confined space. Always install the product in a location with adequate ventilation, at
least 20 in (50 cm) from adjacent surfaces.
•
Be sure that no ventilation slots on the product's housing are blocked.
1.5.3
Power and Wiring
•
Always make sure that the voltage of the outlet to which you are connecting the product is within the
range stated on the decal or rear panel of the product.
•
Make sure the power cord is not crimped or damaged.
•
Never connect this product to a dimmer pack or rheostat.
•
Never disconnect the product from power cord by pulling or tugging on the cord.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
1.5.4
Operation
•
Do not operate this product if you see damage to the housing or cables. Have the damaged parts
replaced by an authorized technician at once.
•
Make sure there are no flammable materials close to this product while it is operating.
•
Do not cover or plug the output nozzle during operation.
•
Do not use the product as a space heater.
•
Never carry the product by the power cord or any moving part. Always use the handles.
- 2 -