- ページ 7

圧着工具 Custom Crimp D160-T420 SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Custom Crimp D160-T420 Series 10 ページ。 Hydraulic hose crimper

CALIBRATION INSTRUCTIONS

Insert any die set and the Compression Plate in the cone base as shown.

•

Note: There should not be a ﬁ tting in the die set when checking calibration.

Set the Micro Crimp Adjuster as follows at "0".

•

Slide the Pusher onto the stud of the hydraulic ram.

•

Press and hold the start/stop switch until the crimper

•

shuts oﬀ for the D165 or apply pressure to the D160 Series

until the die set is completely closed and the white indicator

on the Micro Sight button is just visible.

If the D165 motor shuts oﬀ in approximately 1 second after the die set is fully

•

closed or the white line on the Micro Sight button is just visible, the crimper is cor-

rectly calibrated.

If the crimper requires recalibration, hold the micrometer barrel with a 5/16

•

inch open end wrench and rotate the stem either in or out with a 5/32 inch hex key

wrench.

Rotating the stem out of the barrel decrease the time required for the pump to

•

shut oﬀ .

Recheck calibration.

•

An easily removable Coupling Stop makes repeti-

tive crimps faster by not having to visually align

the ﬁ tting before each crimp.

The adjustable Retraction Stop limits ram

retraction to only the amount required to

remove the hose and coupling saving time

on multiple crimps.