- ページ 7

バイクアクセサリー Custom Dynamics Dynamic Strips CD-DS-ST-CのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Custom Dynamics Dynamic Strips CD-DS-ST-C 7 ページ。

Installation Instructions - Page 7

Tuck Wires up

into the rear of

the fork cover

Test function of the Dynamic Strips™. In running mode, The white LEDs will be on. Test the left turn signal.

The white LEDs will turn off and begin flashing in amber LEDs. Disable left turn and the Amber LEDs will turn

off and engage the White LEDs. Perform this with the Right Turn Signals as well.

Questions? Call us at: 1 (800) 382-1388

Note: This is a very IMPORTANT step. DO NOT SKIP.

Grab both sets of wires with the closed end of your fingers and

push them into the back of the fork cover as shown in the photo.

This should give about 5-6 inches of slack in the wires to allow the

handlebars to turn freely. If you desire, tie wraps may be used to

keep the wires in place.

Everything to Light Up Your Ride®

M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST

09-2017