- ページ 14

サブウーファー Artison RCC300-FSのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Artison RCC300-FS 15 ページ。

microphone at your normal listening position if you plan to use the amplifier in

this setting

b. One Long, Two Short Flashes – Amplifier Error, Shorted Audio Outputs. Remove

the speaker wires from the amplifier and use an ohm meter to check for shorts in the

line.

c. One Long, Three Short Flashes – Over Temperature Indicator. Be sure that the

amplifier has adequate ventilation. If the situation continues to exist contact Artison.

Calibrate Button – Place the supplied microphone

plug it into the AUTO EQ MIC input jack. Press the button for a few seconds to initiate

ARMC sequence.

RCC 300 CABINET MOUNT (RCC300-CM)

The RCC 300 Cabinet Mount is an accessory for the RCC 300 Freestanding Subwoofer. The

RCC300-CM allows the RCC300-FS to be hidden inside of any piece of furniture or built-in

cabinetry. The subwoofer is designed to fit snuggly face-down inside the cabinet mount and

direct the subwoofer's energy down through the bottom of the cabinet and either directly into the

room or out through venting in the cabinet's baseboard.

INSTALLATION

1. Using the supplied Cut-Out Template mark the 12 mounting holes and the cut-out area.

2. Remove the cut-out by using the appropriate method for your application.

3. Mount the cabinet mount to the bottom of the cabinet via the 12 mounting holes in the mount.

Drywall screws approximately 2.5" long are needed to secure the mount or use hardware that

is more appropriate to your application.

When venting the output of the subwoofer through a built-in cabinet's baseboard, please

reference the points below:

a. Please allow for a minimum of 40 in

is provided the subwoofer will be restricted and may cause excessive noise through the

vent.

b. Rounded corners will also minimize noise caused by the excited air.

c. Either multiple smaller vents or one large vent can be used. The subwoofer is not affected

by variations in shape or number of vents, as long as the minimum total open area is

maintained.

in the desired listening position and

of total open area in the baseboard. If less open area