- ページ 5

メディア・コンバーター Artistic License Ether-Lynx IIのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Artistic License Ether-Lynx II 13 ページ。

ページを印刷する

DMX Ports

Ether-Lynx II can convert a maximum of two input universes and four output universes of

DMX512. Each port has a 5-pin XLR connector (male on the inputs, female on the outputs). The

two DMX512 inputs each have a female loop-through connection.

DMX512 Wiring

XLR Pin

Function

(Convention)

Ground

Data +

The DMX512-A standard specifies that Cat5 cable can be used to carry DMX data. The table

above shows which cores should be used. It is recommended that Cat5E cable is used.

For the outputs, RDM data uses the same connections as the DMX data.

DMX Indicators

The LED data indicators (pictured opposite)

have the following meanings:

STAT: ON when unit is powered, flashing if

hardware fault (see 'Error Messages').

NET: ON when network data is active.

DMX: ON when data is transmitted or

received, flashing if merging two universes

(see 'DMX-Workshop').

Power-up: During power-up, the LEDs will

step sequentially.

Boot-loader: When in boot-loader mode (see

page 9), all the LEDs will flash.

If all the LED indicators flash 3 times, this

means that changes to the Sub-Net and

Universe wheels are not honoured because

the value has been set remotely (see

'Universe, Sub-Net and Net' opposite).

Ether-Lynx II User Guide

Colour

Black

Blue

Data -

Red

Ethernet Indication

PWR: Power LED

LINK: ON if there is a valid link between this

connection and another valid Ethernet device.

ACT: Flashes when there is data activity.

SPD: ON if this connection is running at

100BaseT, OFF if running at 10BaseT.

RJ45

Cable Colour

7 & 8

White/Brown &

Brown

Orange

White/Orange

DMX Indication

Universe, Sub-Net and Net

Each

universe

ethernet needs to be distinguishable from

other universes on the same network. For

universe numbers up to 256 (the maximum

limit of Art-Net II), this is achieved by setting

the (4-bit) Universe and Sub-Net numbers.

The settings can be made via the Sub-Net

being

transmitted

Page 5

over