- ページ 3

ソウ CustomCrimp HS-300のPDF マニュアルをオンラインで閲覧またはダウンロードできます。CustomCrimp HS-300 13 ページ。 Hose saw

Counter (HS300 & HS500 Models only)

A resetable counter makes it easy to keep track of the number of cuts made.

Hose Bending Pins

Hose Bending Pins prevent the blade from binding during a cut.

Pins should be positioned in the holes in the saw table such that the hose

opens slightly during the cut. Spread the pins further apart for larger

hoses.

The hose should begin to bend before contacting the blade. This will

increase blade life and keep the hose from tearing and deforming.

Apply steady downward pressure on the handle in order to force the hose

into the blade. Do not apply enough force to stall the blade, and ease up

on the pressure before the blade completes the cut. This will keep from

separating the wires as the blade exits the hose.

Blade Choice

Two blades are available. Choose the correct blade for the type of

hose being cut.

Note: New blades must be properly conditioned to assure long

life and clean cuts. For the ﬁ rst ten cuts, feed the blade slowly

through a medium size hose. this will properly break in and

condition the blade for long life.

Double Bevel Blade with SS Slots

The double bevel smooth blade (P/N 104050) is recommended for braided

hose and will give minimal debris in the cut hose.

NOTE: PAY CLOSE ATTENTION TO THE DIRECTION OF

ROTATION MARKED ON THE BLADE. IT IS THE OPPOSITE OF

MOST BLADES OF THIS TYPE.

Scalloped Blade (General Purpose)

The scalloped blade (P/N 104034) is recommended for all spiral hose.

Note: The edges of the blade may appear to be dull. This does not

mean that the blade is not eﬀ ective. As long as the blade is still

giving clean cuts, do not replace the blade.