- ページ 7
ソウ CustomCrimp HS-300のPDF マニュアルをオンラインで閲覧またはダウンロードできます。CustomCrimp HS-300 13 ページ。 Hose saw
![CustomCrimp HS-300 マニュアル](/uploads/products/server2/867499/867499.jpg)
4
D
Step 4.
Pour 1 bottle of 4 oz of mister oil into the fi ll port (D). Then thread the Fill Plug back in.
2 bottles of 4 oz of mister oil are included, please note reservoir only holds 4 oz (Mister Oil part
number P/N: 104156).
Once the Mister Lubricator has been installed follow the steps below to adjust the air
pressure and oil drops:
Step 5.
Make sure hose saw is still unplugged, and remove side panel (E)
(5 screws) and follow the steps below:
1. Connect air line using quick connect (F)
2. Set air pressure by adjusting valve on the air regulator (G)
3. Adjust the oil drops (H) so that after approximately 10 seconds you see a
small fi lm appear onto the hose saw blade (I).
If the sound of the air going against the blade is too loud, reduce the air
Note:
pressure and increase the oil drop. Adjust the air pressure to a more comfortable
level, then verify that you are getting your small fi lm coverage in approximately
10 seconds.
4. When the hose saw is not in use you can turn off the mister by either option:
a. Un-hook the air disconnect (this allows you not to have to adjust the air pres-
sure each time).
b. Turn off the air regulator (If you use this option we recommend making a mark
on your air pressure gage to show what the desired setting is for quick setup).
5. Place the side panel and bolts back on the hose saw.
The installation and setup of the Mister Kit have been completed.
5 5 5
E
6
I
H
G
F
7