- ページ 14
カメラアクセサリー Customidea GeoPic IIのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Customidea GeoPic II 20 ページ。 Geotagging device for nikon d200/d2hs/d2x/d2xs fuji s5 pro
ページを印刷するFreeze mode (blue)
The following figures represent typical photo counts you
can expect in freeze mode. Bear in mind that these
numbers will depend on your shooting style and camera
setup:
Mode:
Continuous
Low power
Freeze
No GPS
attached
†
3 large res, basic quality JPEGs taken every 2 minutes (more details at end of manual)
It is useful to have a means of recording whether a
photo was taken in freeze mode, to make it clear that the
geotag may not be accurate. For this reason a user
setting is available that replaces the altitude field of the
geotag with the value of '99999m'. If you would like to
enable this option then please see the settings section.
It is important to note that buffered GPS data in freeze
mode is never replaced in either the continuous (red) or
low power (green) modes. Consider the scenario when
the GeoPic II is in low power (green) mode and locked,
then you subsequently change to freeze mode. The
GPS data from low power mode will not be used in
freeze mode. Instead you can either wait for freeze
mode to obtain a lock and replace its buffered location or
cancel the search and use the data from the last time
you obtained a lock in freeze mode.
Nikon D200, D2HS, D2X and D2XS and Fuji S5 Pro are registered
Current consumption:
GeoPic II: ~55mA
Camera: ~300mA
Total: ~355mA regardless of state.
GeoPic II: ~55mA
Camera (standby/metering): ~0.1mA/300mA
Total: (standby/metering): ~55.1mA/355mA
GeoPic II: ~2mA
Camera (standby/metering): ~0.1mA/300mA
Total: (standby/metering): ~2.1mA/302mA
Camera (standby/metering): ~0.1mA/300mA
trademarks or a trademark of their respective companies.
13
Photos:
†
315
†
970
†
1690
†
1750