- ページ 2

セキュリティセンサー Alula RE611PのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Alula RE611P 4 ページ。 Pet immune indoor motion sensor

Pro Tips

Walk test mode is entered by removing the battery for

10 seconds and re-inserting the battery. The red LED

will begin to flash indicating that the motion sensor

is warming up. After 45 seconds, the LED will stop

flashing which indicates the motion sensor is ready

to detect motion. The LED will illuminate each time

motion is detected. Once the LED goes out, the sensor

is ready to detect motion again. Walk test mode ends

after 15 minutes. It is recommended that the RE611P

PIR is tested monthly to ensure proper function.

Mounting tape works great if the surface is properly

prepared and firm pressure is applied for over 10

seconds.

Surface Preparation

• Clean the surface

• Ensure the mounting surface temperature

is above 50 °F

Motion sensitivity can be adjusted by the sensitivity jumper on the circuit board.

• For standard sensitivity motion detection with pet immunity leave the jumper

in the default setting (on).

• Remove the jumper if increased sensitivity to movement is desired.

Pet immunity is optimized when the motion sensor is mounted at 7.5 feet high and

aimed away from house features that could allow pets to be high in the detection field

(e.g. stairs, counter tops, tall furniture).

Motion catch performance is best when the motion sensor is positioned so a person

would typically walk across the front of the motion sensor instead of directly toward

the motion sensor.

Motion Detection Tips

• Provide a clear line-of-sight to the monitored area and remember that glass

blocks infrared energy (PIR = Passive InfraRed).

• Aim away from windows and sunlight.

• Aim away from air conditioners, heaters or heating/cooling vents.

Tamper Switch

Sensitivity Jumper

Battery