- ページ 6

エンクロージャー Alumax SPEEDSTALL 794S SeriesのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Alumax SPEEDSTALL 794S Series 9 ページ。 Shower enclosure

Hold the two 135° posts [J] plumb and carefully

measure horizontally from the top of each wall jamb [E]

to the outside edge of the 135° post. Add 3/16" to each

measurement to find the corresponding dimension on the

header assembly (from the outside mitered edge to the

squared ends) and trim the header assembly to fit.

Using a 3/16" drill bit, drill the interior face of the header

assembly on both ends as shown.

Press the header assembly [D] over the wall jambs

[E], the 135° posts [J] and the pre-glazed panels. Check the

posts for plumb. Adjust as required by varying the overlap

of the header over the wall jambs. You may need to trim the

ends of the header where it meets the wall. The minimum

horizontal dimension for the door opening is the door panel

width (see the graphic in Step #9) plus 1/2", maximum is the

door panel width plus 1 3/4".

Use the holes in the ends of the header and curb as a guide

and drill four 1/8" holes into the wall jambs. Drill 1/8" holes

thru the header and curb into each 135° post as shown, then

enlarge the outer holes with a 3/16" drill for clearance on the

self-tapping screws. Secure the header and curb to the wall

jambs and posts with eight #8 x 1/4" truss head screws [C].

Strip two clear vinyl jamb seals [K] into the door

panel [L] splash guard and the pivot jamb [M] and trim

flush at both ends. Both vinyls should be turned to trap

water from the shower head. Secure the vinyls with a

small quantity of glue or caulk at each end or by carefully

crimping the vinyl pocket. Set the door panel aside.

Press the pivot jamb and strike jamb [N] (with magnetic

strip) over the two 135° posts [J]. Refer to Step #1 for the

proper handing of the door.

NOTE: The magnetic strip on the strike jamb must face

the exterior and the clear vinyl jamb seal on the pivot

jamb must face inward.

G03711103

8-22-06

Page 6 of 9