- ページ 12

IPアクセスコントローラ DKS 1520 seriesのPDF 設置および取扱説明書をオンラインで閲覧またはダウンロードできます。DKS 1520 series 16 ページ。 Stand alone card readers or controller
DKS 1520 series にも： マニュアル (2 ページ)

ページを印刷する
DKS 1520 series 設置および取扱説明書
2.5.3 Delete a Single Card Code
This programming sequence deletes a single card code and takes it completely out of memory to free up space for other card
codes. Card codes not programmed in the 1520 will not print or be stored in the transaction buffer. If you want a transaction of
denied card codes (for example - a lost card), then assign time zone 00 (always deny entry) in card programming 2.5.1.
1. Press
1 8 and enter the MASTER CODE. [
*
2. Enter a five-digit card code to be deleted, then press
3. Repeat step 2 to erase additional card codes, one at a time.
4. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.5.4 Delete ALL Card Codes
CAUTION: This programming sequence will delete ALL card codes that have been previously programmed into the 1520.
This cannot be UNDONE.
1. Press
1 3 and enter the MASTER CODE. [
*
2. Enter 9 9 9 9, then press
3. A long beep after approximately 1-2 seconds indicates that all card codes are deleted and programming ends.

2.6 Facility Codes

Facility codes can be used to prevent the same card code from working at a different site or facility.
The 1520 allows you to enter up to 10 different facility codes and allows you to decide whether to use facility codes or not.
Facility codes are three-digits in length. Valid facility codes are 000 – 255. Simply entering a facility code does not turn this
feature on. It is programmed to turn ON or OFF in section 2.6.2.
2.6.1 Programming Facility Codes
1. Press
0 5 and enter the MASTER CODE. [
*
2. Enter a single-digit facility code number (0 - 9), then press
1= FC 1, 2= FC 2, etc. Use 0 for FC 10
3. Enter the three-digit facility code number (000 - 255), then press
4. Repeat steps 2 - 3 to enter additional facility codes.
5. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.6.2 Turning Facility Codes ON / OFF
Factory setting for this feature is OFF (0).
1. Press
2 8 and enter the MASTER CODE. [
*
2. Enter 0 to turn facility codes OFF or enter 1 to turn facility codes ON, then press
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
10
1 8 _ _ _ _ (beep)]
*
1 3 _ _ _ _ (beep)]
*
. [ 9 9 9 9
(beep)]
*
*
0 5 _ _ _ _ (beep)]
*
2 8 _ _ _ _ (beep)]
*
. [ _
(beep)]
*
*
. [ _
(beep)]
*
*
. [ _ _ _
(beep)]
*
*
. [ _
(beep)]
*
*
1520-065-E-7-16