- ページ 6
IPアクセスコントローラ DKS 1520 seriesのPDF 設置および取扱説明書をオンラインで閲覧またはダウンロードできます。DKS 1520 series 16 ページ。 Stand alone card readers or controller
DKS 1520 series にも： マニュアル (2 ページ)
ページを印刷する
Do not mount the 1520 card reader to a moving gate, or immediately next to a gate panel or pedestrian gate. Continuous
vibration from slamming gates and vibration can cause damage to the system over time.
WARNING!
If the card reader is used to activate a vehicular gate operator, it must be mounted a minimum of 10 feet away
from the gate and gate operator, or in such a way that the user cannot come into contact with the gate or gate operator
while using the device.
1.1 Remove Components from Cabinet
1. Open housing with key.
2. Remove four (4) 6-32 x ¼ screws from the corners of the keypad mounting plate. Remove faceplate from Card Reader with 2
locknuts and remove and store components (still wired to circuit board) in a safe place.
6-32 x ¼ screw
Keypad Mounting Plate
6-32 x ¼ screw
Faceplate Locknut
1.2 Mount Cabinet
Card Reader on a Mounting Post
Use existing 4 holes in cabinet box to
bolt the surface or wall mount
models on a DoorKing mounting
post. Use the hardware that is
supplied with the mounting
post.
Note: A gooseneck
mounting post
anchored in
concrete does not
make a good
ground.
4
SECTION 1 - INSTALLATION
6-32 x ¼ screw
1
2
3
1520 Card Readers
4
5
6
AWID Reader P/N 1520-080
7
8
9
HID P/N 1520-082
0
DK Prox Reader P/N 1520-084
6-32 x ¼ screw
Faceplate Locknut
Faceplate
Run ALL wires that will be
needed during the cabinet
installation and connect to
18-pin terminal. See Section
1.4 1520 Wiring.
Use the 4 existing holes in
the cabinet. Run conduit
inside of wall or pilaster. Use
appropriate hardware to
mount the cabinet (Not
supplied). Be sure that the
mounting hardware does not
protrude into the cabinet
where it could cause a short.
6-32 x ¼ screw
Keypad Mounting Plate
1
2
4
5
7
8
0
6-32 x ¼ screw
Either model 1520 can be mounted directly to a wall
or pilaster. The card reader can be post mounted
using a DoorKing mounting post (there are several
different styles available). Be sure card reader is
securely mounted and is not subject to continuous
vibration from closing doors or gates.
Card Reader Mounted Directly
Plastic screw anchors
for masonry if required.
(Not supplied)
1/2" Conduit
6-32 x ¼ screw
3
1520 Controller
6
P/N 1520-081
9
6-32 x ¼ screw
to a Wall or Pilaster
1520-065-E-7-16