- ページ 2

バイクアクセサリー Artotic SUN9BのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Artotic SUN9B 9 ページ。 Auto darkening filter welding helmet

1. BEFORE WELDING

--Auto-Darkening Filter Welding Helmet comes ready for use. The only thing you

need to do before your welding is to adjust the position of the headband and select the

correct shade number for your application.

--Check the front cover lens to make sure that they are clean, and that no dirt is

covering the four sensors on the front of filter cartridge.

Also check the front/inside cover lens and the front lens retaining frame to make sure

that they are secure.

--Inspect all operating parts before use for signs of wear or damage. Any scratched

cracked, or pitted parts should be replaced immediately before using again to avoid

severe personal injury.

--Check for light tightness before each use.

--Select the shade number you require at the turn of a shade knob.

Finally, be sure that the shade number is the correct setting for your application.

--Adjust headband so that the helmet is seated as low as possible on the head and

close to your face. Adjust helmet's angle when in the lowered position by turning the

adjustable limitation washer.

--Choose the weld/grind switch position correctly before welding.

The filter can be assembled with magnifying lens conveniently, please purchase

magnifying lens if need.