- ページ 9

ラボラトリー機器 DLab Thermo Control H100-ProのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DLab Thermo Control H100-Pro 19 ページ。

this button, the time characters of

the setting area are flashing . In

timed working mode, the time

shows the countdown time. In

continuous working mode, the

time show running time. Refer

to below figure.

Mixing speed setting button, when

press this button, the speed

Speed

characters of the setting area are

flashing （Thermo mix models）

At parameter setting state, rotate

this knob can input values; When

finish the parameters setting, push

Adjustable knob

it to start work. At working state,

short push to pause; Long push to

stop working

5 Operation

A. Respectively, press the function button,

the corresponding characters of the setting area are

flashing

B. Rotate parameter knob, input the target parameters.

C. Wait 3s, the corresponding character will stop

blinking, complete parameter setting.

Note: when power on, the setting area of the screen will

display parameters of the last run.

When the time is adjusted to 00:00, means the product

will run the continuous mode.

1.Start: When finish the parameter input, push the

adjustable knob to start work. And in the last line in

the actual value area will display the characters

"Run". Refer to below figure.