ページを印刷する
Remove all packaging materials before assembling the patio
heater.
Before Assembly:
•
Please read all instructions thoroughly before proceeding
with the appliance assembly.
•
Find a large clean area in which to assemble the patio
heater.
•
Please refer to the parts list and diagrams. (see page 7)
•
Assembly of the heater involves large components and it is
advisable to have two people to assemble the unit.
Fig.A
If you have bought a new gas cylinder, the cylinder needs to be
purged (emptied out), before it's first use. If it is not purged of air,
the heater will not work properly. This should happen at the gas
filling station when you fill up the cylinder. Always check this with
your gas supplier.
1.
Before removing this heater from the packaging, read this
manual in full and make sure that it is what you want /need.
2.
Remove the heater from the packaging
3.
Check if the nose cone sealing washer is in place, secure
and in good condition. (Figure B)
4.
The regulator goes directly into the cylinder valve. Always
ensure that the regulator is correctly and firmly fastened in
place. The use of any adaptors is illegal.
ASSEMBLY
This patio heater makes use of an
industrial cylinder (9kg ALVA cylin-
der recommended) with a 5/8" BSP
thread; horizontal exit valve.
The Bullnose regulator supplied
with the heater tightens to the left
hand side (anti-clockwise). (Figure
A).
HEATER SET UP
2