- ページ 12

パティオ・ヒーター Alva GHP50のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Alva GHP50 18 ページ。 Wall mounted patio heater

Step 7

Assemble the Rear Mounting Bracket

Use 4pcs M8x20 Screws and 4pcs M8 nut to assemble the heater to the rear bracket.

Adjust the heater angle and tighten the screws.

1. Connect the regulatorsold (sold separately and to be supplied by installer) to the cylin-

der and the hose to both (sold separately and to be supplied by installer) the regulator

and the appliance hose connector. Fasten with the hose clamps.

2. When attaching the regulator to the cylinder, check that the

rubber nose cone is in place, secure and in good condition, see Fig B.

3. Open the gas cylinder valve and do a leak test, see page 10.

4. DO NOT light the heater when performing this leak test.

5. After passing the leak test, insert a AAA battery into battery compartment for the auto

ignition to operate.

Additional Steps

Orientation of

Assembly

Rear mounting

Bracket

Gas inle

applianc