- ページ 6

フェンス＆ゲート Alvarado CSGのPDF インストールとメンテナンスの説明書をオンラインで閲覧またはダウンロードできます。Alvarado CSG 10 ページ。 Bi-directional waist high security gate

Installing the Directional Adapter Bracket

Alvarado's default configuration for the CFG, CSG, and SSG gates is bi-directional (without the directional adapter

bracket installed). To configure a left- or right-hand only swing, install the directional adapter bracket per the

instructions below:

14. Swing the gate to the open position.

15. Using a 3/16" Allen wrench and (2) socket head cap screws, secure the directional adapter bracket to the lower

hinge post according to the desired swing direction [Figure 8].

16. Insert the first 1/4" flat point set screw and tighten it with an 1/8" Allen wrench until the flat point of the set screw

protrudes out of the opposite side of the adapter bracket. Swing the gate into the 'closed' position and adjust the

set screw until the gate is in proper visual alignment. Once the 'closed' position is properly aligned, insert the

second set screw and tighten it until it's stopped by the first set screw [Figure 8].

Fig. 8

Left-Hand /Right-Hand Swing Configurations

The swing limit set screw can be used to limit the gate

arm's degree of travel and/or prevent overtravel.

Use an 1/8" Allen wrench to adjust the set screw

[Figure 10]:

•

Turn the set screw counter-clockwise to decrease

the gate arm's degree of travel.

•

Turn the set screw clockwise to increase the

degree of travel (to maximum).

Page 6

PUD3570R2-0

CSG/SSG/CFG Installation and Maintenance Instructions

Directional Adapter Bracket

Flat Point Set Screws

Socket Head Cap Screws

For Assistance: [email protected] (909) 591-8431

Fig. 10

Adjusting the Swing Limit

Swing Limit Set Screw

Created on: 10/7/2013