- ページ 11

フェンス＆ゲート Alvarado MSGXのPDF インストールとメンテナンスの説明書をオンラインで閲覧またはダウンロードできます。Alvarado MSGX 20 ページ。 Full height maximum security gate

MSG Installation and Maintenance Instructions

Magnetic / Electric Strike Lock Wiring (Cont.)

Power Supply Specifications

Input:

120VAC, 60Hz, 17W

Output:

+12VDC, 1.0A

The power supply is to be installed near the gate location. Ensure power supply enclosure is weatherproofed.

WARNING

1. Pull 18 gauge cable through the conduit (if used) from the power supply and switch location to the wire access

hole located at the top corner of the gate door on the push side of the gate frame post. [Figure 6]

2. Identify the wiring diagram appropriate for your locking device on Wiring Instructions (Cont.).

Refer to Figure 7 for Magnetic Lock / Fail Safe Electric Strike wiring diagram and Figure 8 for Fail Lock Electric

Strike wiring diagram.

3. At the gate, connect the POSITIVE (+) RED wire coming out of the lock device to the common terminal of the

device providing the sustained activation signal (access switch, push button, etc.) Connect the NEGATIVE (-)

BLACK wiring coming out of the lock device to the NEGATIVE (-) BLACK power supply lead wire.

4. Connect the POSITIVE (+) BLACK/WHITE DASHED STRIPE wire coming out of the power supply to the

appropriate terminal of the device providing the sustained activation signal (access switch, push button, etc.).

5. Plug the power supply into appropriate power source. For both Fail Lock and Fail Safe units, the gate should

lock when power is supplied (if wired correctly). Press and hold the gate activation button: if the gate is functioning

correctly, the lock will release and the gate will unlock.

PUD1201R5-0

120V

Ensure primary power to the unit is off before any wire connections are made.

For Assistance: [email protected] +1 (909) 591-8431

220V

Input:

220VAC, 50Hz, 20W

Output:

+12VDC, 1.25A

Page 11