- ページ 11
サーモスタット 1-CUBE SU 6.2.のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。1-CUBE SU 6.2. 13 ページ。 Water thermostat
ページを印刷するCalibration of the upper temperature 70 degrees Celsius (point 2) :
First check if the temperature in bath is about 70 degrees Celsius and if it is not use the method Thermostat to reach
it. Once temperature of 70 degrees Celsius is reached use the following procedure:
1) Press the keys OFF and ENTER at the same time
2) There is text „dig value of tem" on the first line and the value on the second line. Write down the digital
value.
3) There is text „point 1 - digital" on the first line and the value on the second line. Do not set the point 1 at
this moment therefore press the key „OFF".
4) There is text „point 1 - temp" on the first line now and the value on the second line. Do not set the point 1 at
this moment therefore press the key „OFF".
5) There is text „point 2 - digital" on the first line now and the value on the second line. Overwrite the value
with the help of keys
before. Press the key „OFF" to set the required value.
6) There is text „point 2 - temp" on the first line now and the value on the second line. Overwrite the value with
the help of keys
etalon in the water of the water bath. Press the key „OFF" to set the required value.
7) There is text „HYSTER1_0= " on the first line now and the value on the second line. Do not set HYSTER1_0=
at this moment therefore press the key „OFF".
8)
There is text „HYSTER1_100= " on the first line now and the value on the second line. Do not set
HYSTER1_100= at this moment therefore press the key „OFF".
9) There is text „HYSTER2_0= " on the first line now and the value on the second line. Do not set HYSTER2_0=
at this moment therefore press the key „OFF".
10) There is text „HYSTER2_100= " on the first line now and the value on the second line. Do not set
HYSTER2_100= at this moment therefore press the key „OFF".
11) There is text „HYSTER3_0= " on the first line now and the value on the second line. Do not set HYSTER3_0=
at this moment therefore press the key „OFF".
12) There is text „HYSTER3_100= " on the first line now and the value on the second line. Do not set
HYSTER3_100= at this moment therefore press the key „OFF".
The upper temperature (point 2) and temperature sensor are calibrated now
+ (increase ) or – (decrease) to put the digital value that you have written down
+ (increase) or – (decrease) to put the value that you have measured before with the
11