- ページ 4
カー・アンプ DLS CLASSICAMPENG03のPDF インストールと操作方法をオンラインで閲覧またはダウンロードできます。DLS CLASSICAMPENG03 16 ページ。
ページを印刷する
Wiring
Power and Outputs
Power terminal ( +12V)
Connect the fuse holder as close to the vehicle
battery + as possible, using AWG 8 = 10 mm
heavier cable. Use ring crimp terminal cable to
connect to battery +. Apply silicon grease to the
fuse to prevent corrosion
DLS
DLS FH1
fuse holder
Connect the battery cable by a crimp fork terminal
( spade ) to the +12 Volt on the amplifier. If you use
2
a AWG 8 = 10 mm
or thinner cable, you can do
without the crimp terminal and put the cable right
into the connector.
Be sure to use a rubber grommet or a plastic
insulating tube where the cable passes the firewall
or other places when it can easily be jammed.
Use ty-wraps to secure to existing cables in the
engine compartment.
Ground Terminal ( GND )
Connect to a good chasis ground. The ground
connection should be clean, unpainted metal to prov-
ide a good electrical connection. Use a wire brush,
a scraper or a piece of an abrasive sheet to clean
the metal. Use a lock washer or two to secure
contact. Protect with silicon grease or by paint
applied afterwards.
+12V REM GND
4
Remote terminal ( REM )
For RCA cable signal input:
Connect the radio power antenna lead = remote
turn on/off from the car stereo to the amplifier
remote connection. This turns on the amplifier
whenever the car stereo is turned on.
2
or
You can either use the built in remote cable in the
RCA cable itself or use a separate cable as seen
on page 4.
Sometimes a small disturbance may enter the
amplifier coming from the remote voltage , through
+12V REM GND
the built in remote wire and into the RCA cable.
Thus we recommend to use a separate remote wire
and run the RCA lead separate from remote wire,
power cables and speaker cables.
You can either use a crimp fork terminal or insert
the cable directly into the amplifier terminal. If there
is no remote voltage available from the stereo, you
must connect to the ignition key through the radio
or any accessories fuse.
For High Level input:
We recommend you to connect the remote wire as
described above. The amplifier will produce soft
on / soft off operation this way. You must set the Hi
level/Low level switch to Low level position in this
case.
In the case that there is no remote voltage available
from the car stereo or you want to simplify the in-
stallation, the amplifier can be turned on/ turned
off by the high level input voltage. This is done when
the Hi level/Low level switch is set to Hi level posi-
tion. There is a small disadvantage that this function
gives soft turn off operation but some plop sound
when switching off.
Fuses
Use only one or two 25 ampere ATC blade type
fuses. CA 50 uses three 30 ampere fuses.
CA20, 21, 40 & 50
+12V REM GND