- ページ 10

プロジェクター 3M Digital Projector X75のPDF 製品安全マニュアルをオンラインで閲覧またはダウンロードできます。3M Digital Projector X75 14 ページ。 Safety guide
3M Digital Projector X75 にも：パンフレット＆スペック (4 ページ), クイック・スタート・マニュアル (4 ページ), クイック・スタート・マニュアル (4 ページ), 仕様 (2 ページ)

Lamp Operation:

The following symptoms may indicate a lamp in need of replacement:

• LAMP indicator lights up red.

• "CHANGE THE LAMP" message appears on the screen.

•

To reduce the risk associated with air or ground water contamination, which if

not avoided could result in death or serious injury:

The lamp in this product contains mercuy. Dispose of projection lamp in a manner

that is consistent with your local hazardous waste regulations for mercury.

For recycling and disposal information, contact your respective governmental

agencies.

In U.S., contact the Electronic Industries Alliance at www.lamprecycle.org

In Canada, contact the Electronic Product Stewardship Canada at www.epsc.ca

Display Lamp Operation Hours

To determine the lamp operation hours, follow these steps:

1. While the projector is running, press the MENU button on the remote control.

Choose the "OPTION" using the

Choose the "LAMP TIME" using the

2. The operating time of the lamp will be displayed. The message "CHANGE THE LAMP,

AFTER REPLACING LAMP RESET THE LAMP TIMER" will appear after the lamp

operating hours have reached the end of the normal lamp life. The message "POWER

WILL TURN OFF AFTER 20 HOURS" will appear when 20 or less lamp hours remain.

The number of hours left until shut down will decrease until 0 hour is reached, then

power will be turned off.

After normal lamp operating time has expired, the projector will only run for 10-minute

intervals when restarted until the lamp is replaced and the lamp timer is reset. The message

"CHANGE THE LAMP" will blink at projector start up to remind you to change the lamp.

Reset Lamp Hours

While the projector is running, press the MENU button on the remote control.

Choose the "OPTION" using the

button.

2. Choose the "LAMP TIME" using the

the remote control for 3 seconds.

3. The reset menu will then appear. After you replace the lamp with a new lamp, select

"RESET" on the menu with the

Lamp

WARNING

button, and press the

√ Note

button, and press the

button.

3M™ Multimedia Projector X75 Product Safety Guide

button or the ENTER button.

button.

button or the ENTER

button, and press and hold the RESET button on