- ページ 9

音楽機材 BLUE CHIP AIX-101のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。BLUE CHIP AIX-101 15 ページ。 6/4-string guitar/bass

ページを印刷する

Installing the Pickup

Once you've installed the controller, the pickup

can be installed using either double-sided tape

or screws. Although the tape is convenient, screw-

installation is recommended because it provides

greater security and allows pickup height adjust-

ment for optimum performance.

I Hardware

The following parts, supplied with the AIX-

101/102, are required or optional for installation of

the pickup. Please make sure you have all the

parts.

•

Self-tapping round-head

screws (3x25mm) ............... 2

•

Springs ................................ 2

•

Double-sided adhesive

tape ..................................... 4

•

Pickup cushion ................... 1

•

Pickup spacers A

(1mm) ................................. 5

•

Pickup spacers B

(0.3mm) ............................ 10

•

Re-usable double-sided adhesive

pads .................................... 2

Installation

I Installation Procedure — Tape

1. Mark the optimum position for

installation.

The pickup should be located between the

bridge pickup and bridge, ideally 20-mm from the

bridge. If the ideal 20-mm placement is not

possible, the pickup should be located as far as

possible, but no more than 20 millimeters away

from the bridge. The cable end of the pickup

should be oriented toward the sixth string (low E).

One pair of the pickup's magnetic yokes should be

under each string. String spacing varies somewhat

on different guitars, and the pickup will function

properly as long as each string passes over part of

the corresponding yokes (not necessarily the exact

center). Check that the strings pass over the yokes,

even when bending the strings.

Bridge pickup

Pickup

String

Pickup's magnetic yokes

I NOTES

• Make sure the pickup does not interfere with the

operation of a tremolo arm or other guitar controls.

Once the pickup has been positioned correctly,

carefully mark the position on the guitar body.

Small pieces of marking tape can be used if you

don't want to mark directly on the guitar body.

Bridge

No more than

20 millimeters (3/

4")