- ページ 6

自動車アクセサリー Dobinsons BU63-3675のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dobinsons BU63-3675 13 ページ。 Bullbar for vw amarok

ページを印刷する

17. Tighten all nuts and bolts on both sides of the

chassis brackets.

18. The installer may also re-install the plastic

cover plate but enlarging the original front

holes to fit over the bolts and nuts in the

bullbar bracket, this is the installer's choice

and is recommended.

19. Fit the winch cradle bracket (item no.2) to the

left and right chassis brackets as per page 3

with nuts, bolts and washers supplied.

20. Carefully un-wrap the bulbar taking care not

to scratch it especially on the top loops.

Reinstall the number plate. If installing driving

lights to the bullbar it is easiest to install now.

21. If not installing a winch skip to step 29.

22. See the Installation section of your Dobinsons

4x4 Winch manual for specific detailed fitting

instructions. For a brief overview see the

following steps.

23. Test fit your winch to the mounting bracket

and do up loosely with the clutch handle on

the left hand side of the vehicle.

24. This will require the clutch handle and gear-

box housing to be rotated forward one or 2

bolt holes to allow easy access through the

bulbar holes. See instructions in winch user

manual.

Dobinsons Springs and Suspension

25. Determine where the winch control box will

be located and mount the control box. See

instructions in winch user manual for control

box mounting options. If mounting to the top

of the bullbar using the supplied bracket,

check clearance of control box to grill and also

check where the wires will route as if the

wires are passing through the holes in the top

of the bullbar the control box may not be able

to be wired until the bullbar has been fitted as

below.

26. Wire the winch up as per the winch

instruction manual and bolt the winch to the

mounting bracket, ensure the mounting bolts

are not too long and tighten correctly. Route

the wires and connect to battery and also

route the breather hose.

27. Unwind some cable from the winch, and pass

the cable through the fairlead hole in the

bullbar and through the roller fairlead. This

may require removing a circlip from the

fairlead and re installing once the cable is

passed through.

28. Install the roller fairlead into the bulbar.

29. Check the poly bulbar over riders, fog light

and top loop bolts are tight (Do not over

tighten the stainless steel loop mounting

bolts. Do not over tighten the poly bullbar

over riders as they will pull the over riders out

of shape).

30. Wire up the lights. Using a multimeter or test

light first locate the earth wire, parker positive